1
Restoration / Re: bellhousing alignment-any new info?
« on: May 18, 2024, 06:14:45 PM »
My transmission went through needle bearing pilot bushings a lot. Here is a past CRG thread. Check out my reply #12. I used a magnetic gauge from Harbor Freight to dial in the bellhousing alignment. http://www.camaros.org/forum/index.php?topic=16097.0
I stopped using the needle bearing and went back to the bronze bushing now that the alignment is dialed in correctly.
Mike
I stopped using the needle bearing and went back to the bronze bushing now that the alignment is dialed in correctly.
Mike