Camaro Research Group Discussion > Originality
Grille color on a X44?
KevinW:
--- Quote from: rsr on September 16, 2014, 04:37:49 PM ---Thanks Kevin for posting that pic...Did you find any signs of it being mask off on the back side to keep from getting on the argent? I would guess the amount of overspray would vary as well?
--- End quote ---
I don't recall looking for that kinda evidence :) but the back was not painted with silver, only from the front, so the back edges did not have silver. It appeared to be painted on a rack facing front and the body color being painted to cover the outside edges that show. That is where the overspray came from. There was little overspray on the bottom of the grill.
Mark:
Original grilles were cast in both silver and black plastic, the body color was applied to the proper base colored grille. There were 4 different grilles, black and silver non RS grilles, and black and silver RS grilles. The grill sections were never painted on grilles from the factory. GM eventually dropped the silver cast grilles from their service parts and only retained the 2 black ones, so after that point all SS, and Z28 standard grilles and RS grilles going on Black cars had to have the center sections painted silver, along with the body color around the perimeter.
Don't know what kind of rack the grilles were on when they got painted, but there had to be a center mask that fit over the grille sections to keep overspray off the grilles. No one masked each grill with tape.
KevinW:
Mark, I did notice the center of my grill was silver as opposed to the plastic grey look of the grill. I would have thought the factory painted the silver (no mask), then masked the center and sprayed the body?
Mark:
That would defeat the purpose of havine silver and black cast parts. It all comes down to labor in an assembly line, if you have to paint the center of the grille silver wait for it to dry then mask and paint the surround, later theres a lot of wasted man hours, plus there would be no reason to have a silver and a black cast grille in your parts bins. if you just had a mask that fit into the headlight bucket openings and covered the grille area all you have to do is put the mask on, spray the surround and move on to the next. These guys on the line had just over a minute to mask and paint a grille at Norwood as that's the speed the cars were passing thru your station. They needed 912 of these grilles painted every day of the week.
KevinW:
Hmm, then it must have been painted later in its life.
Navigation
[0] Message Index
[#] Next page
[*] Previous page